Hi folks!!!!

You have opened my mind on this!

Thanks so much

I realized that I didn't configure out anything during the installation of the docker.... a poor man!

Now is working perfectly:

Just install using the docker container of zerpex, set the advance setting as suggested by Kenji et voilà nothing else. QNAP takes care of everything about ports and so on

Only thing to be done to complete the installation, address the port 2202 to the NAS in the  router to access remotely and for dynamic IP set up DDNS always in the router (I use no-IP service)

Now I am happy man because I learnt a lot and I can store, read and download everywhere to any devices my ebooks and comics!

thanks again!

Hi,

thanks for reply

I am sorry too :-(

I am a newbie! so I just used the "app" installed from Qnap App Center named "container station" and it creates the docker where I download your package "zerpex/ubooquity-docker"

That's it!

In the meantime I discovered that my port 2202 and 2502 are not opened !!! I did the port-forwarding in my router but they are still down :-(

I need to check with my ISP .....

MontyJ

did you solve the issue?